Juniper JUNOS 21.1 R3-S3

An Improper Check for Unusual or Exceptional Conditions vulnerability in the chassis management daemon (chassisd) of Juniper Networks Junos OS allows an unauthenticated, network-based attacker to cause a Denial-of-Service (DoS). If an attempt is made to access specific sensors on platforms not supporting these sensors, either via GRPC or netconf, chassisd will crash and restart leading to a restart of all FPCs and thereby a complete outage. This issue affects Junos OS: * 21.4 versions from 21.4R3 before 21.4R3-S5, * 22.1 versions from 22.1R3 before 22.1R3-S4, * 22.2 versions from 22.2R2 before 22.2R3, * 22.3 versions from 22.3R1 before 22.3R2-S2, 22.3R3, * 22.4 versions from 22.4R1 before 22.4R2. This issue does not affect Junos OS versions earlier than 21.4.

Published: 2024-07-11T16:04:13.075Z
Updated: 2024-08-02T04:26:15.620Z

A Use After Free vulnerability in command processing of Juniper Networks Junos OS on MX Series allows a local, authenticated attacker to cause the broadband edge service manager daemon (bbe-smgd) to crash upon execution of specific CLI commands, creating a Denial of Service (DoS) condition.  The process crashes and restarts automatically. When specific CLI commands are executed, the bbe-smgd daemon attempts to write into an area of memory (mgd socket) that was already closed, causing the process to crash.  This process manages and controls the configuration of broadband subscriber sessions and services.  While the process is unavailable, additional subscribers will not be able to connect to the device, causing a temporary Denial of Service condition. This issue only occurs if Graceful Routing Engine Switchover (GRES) and Subscriber Management are enabled. This issue affects Junos OS: * All versions before 20.4R3-S5, * from 21.1 before 21.1R3-S4, * from 21.2 before 21.2R3-S3, * from 21.3 before 21.3R3-S5, * from 21.4 before 21.4R3-S5, * from 22.1 before 22.1R3, * from 22.2 before 22.2R3, * from 22.3 before 22.3R2;

Published: 2024-04-16T20:03:56.292Z
Updated: 2024-08-02T01:32:07.268Z

An Unsupported Feature in the UI vulnerability in Juniper Networks Junos OS on MX Series and EX9200 Series allows an unauthenticated, network-based attacker to cause partial impact to the integrity of the device. If the "tcp-reset" option is added to the "reject" action in an IPv6 filter which matches on "payload-protocol", packets are permitted instead of rejected. This happens because the payload-protocol match criteria is not supported in the kernel filter causing it to accept all packets without taking any other action. As a fix the payload-protocol match will be treated the same as a "next-header" match to avoid this filter bypass. This issue doesn't affect IPv4 firewall filters. This issue affects Juniper Networks Junos OS on MX Series and EX9200 Series: * All versions earlier than 20.4R3-S7; * 21.1 versions earlier than 21.1R3-S5; * 21.2 versions earlier than 21.2R3-S5; * 21.3 versions earlier than 21.3R3-S4; * 21.4 versions earlier than 21.4R3-S4; * 22.1 versions earlier than 22.1R3-S2; * 22.2 versions earlier than 22.2R3-S2; * 22.3 versions earlier than 22.3R2-S2, 22.3R3; * 22.4 versions earlier than 22.4R1-S2, 22.4R2-S2, 22.4R3.

Published: 2024-01-12T00:55:07.323Z
Updated: 2025-06-17T21:09:19.924Z

An Improper Neutralization of Equivalent Special Elements vulnerability in the Packet Forwarding Engine (PFE) of Juniper Networks Junos OS on PTX Series allows a unauthenticated, adjacent attacker to cause a Denial of Service (DoS). When MPLS packets are meant to be sent to a flexible tunnel interface (FTI) and if the FTI tunnel is down, these will hit the reject NH, due to which the packets get sent to the CPU and cause a host path wedge condition. This will cause the FPC to hang and requires a manual restart to recover. Please note that this issue specifically affects PTX1000, PTX3000, PTX5000 with FPC3, PTX10002-60C, and PTX10008/16 with LC110x. Other PTX Series devices and Line Cards (LC) are not affected. The following log message can be seen when the issue occurs: Cmerror Op Set: Host Loopback: HOST LOOPBACK WEDGE DETECTED IN PATH ID <id> (URI: /fpc/<fpc>/pfe/<pfe>/cm/<cm>/Host_Loopback/<cm>/HOST_LOOPBACK_MAKE_CMERROR_ID[<id>]) This issue affects Juniper Networks Junos OS: * All versions earlier than 20.4R3-S8; * 21.1 versions earlier than 21.1R3-S4; * 21.2 versions earlier than 21.2R3-S6; * 21.3 versions earlier than 21.3R3-S3; * 21.4 versions earlier than 21.4R3-S5; * 22.1 versions earlier than 22.1R2-S2, 22.1R3; * 22.2 versions earlier than 22.2R2-S1, 22.2R3.

Published: 2024-01-12T00:53:38.834Z
Updated: 2025-06-17T21:09:19.373Z

A Missing Release of Memory after Effective Lifetime vulnerability in the Packet Forwarding Engine (PFE) of Juniper Networks Junos OS on MX Series allows an adjacent, unauthenticated attacker to cause a Denial of Service (DoS). If an MX Series device receives PTP packets on an MPC3E that doesn't support PTP this causes a memory leak which will result in unpredictable behavior and ultimately in an MPC crash and restart. To monitor for this issue, please use the following FPC vty level commands: show heap shows an increase in "LAN buffer" utilization and show clksync ptp nbr-upd-info shows non-zero "Pending PFEs" counter. This issue affects Juniper Networks Junos OS on MX Series with MPC3E: * All versions earlier than 20.4R3-S3; * 21.1 versions earlier than 21.1R3-S4; * 21.2 versions earlier than 21.2R3; * 21.3 versions earlier than 21.3R2-S1, 21.3R3; * 21.4 versions earlier than 21.4R2; * 22.1 versions earlier than 22.1R2.

Published: 2024-01-12T00:53:23.497Z
Updated: 2025-06-16T18:33:32.215Z