Cisco IOS XE 17.11.1

A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS Software and Cisco IOS XE Software could allow the following: An authenticated, remote attacker with low privileges could cause a denial of service (DoS) condition on an affected device that is running Cisco IOS Software or Cisco IOS XE Software. To cause the DoS, the attacker must have the SNMPv2c or earlier read-only community string or valid SNMPv3 user credentials. An authenticated, remote attacker with high privileges could execute code as the root user on an affected device that is running Cisco IOS XE Software. To execute code as the root user, the attacker must have the SNMPv1 or v2c read-only community string or valid SNMPv3 user credentials and administrative or privilege 15 credentials on the affected device. An attacker could exploit this vulnerability by sending a crafted SNMP packet to an affected device over IPv4 or IPv6 networks. This vulnerability is due to a stack overflow condition in the SNMP subsystem of the affected software. A successful exploit could allow a low-privileged attacker to cause the affected system to reload, resulting in a DoS condition, or allow a high-privileged attacker to execute arbitrary code as the root user and obtain full control of the affected system. Note: This vulnerability affects all versions of SNMP.

Published: 2025-09-24T17:10:42.891Z
Updated: 2026-02-26T17:48:03.098Z

A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with administrative privileges to execute arbitrary commands as root on the underlying operating system of an affected device. This vulnerability is due to insufficient validation of user arguments that are passed to specific CLI commands. An attacker could exploit this vulnerability by logging in to the device CLI with valid administrative (level 15) credentials and using crafted commands at the CLI prompt. A successful exploit could allow the attacker to execute arbitrary commands as root.

Published: 2025-09-24T17:14:57.638Z
Updated: 2026-02-26T17:48:00.835Z

A vulnerability in the packet filtering features of Cisco IOS XE SD-WAN Software could allow an unauthenticated, remote attacker to bypass Layer 3 and Layer 4 traffic filters. This vulnerability is due to improper traffic filtering conditions on an affected device. An attacker could exploit this vulnerability by sending a crafted packet to the affected device. A successful exploit could allow the attacker to bypass the Layer 3 and Layer 4 traffic filters and inject a crafted packet into the network.

Published: 2025-05-07T17:38:49.862Z
Updated: 2025-05-07T19:41:59.096Z

A vulnerability in the Network Configuration Access Control Module (NACM) of Cisco IOS XE Software could allow an authenticated, remote attacker to obtain unauthorized read access to configuration or operational data. This vulnerability exists because a subtle change in inner API call behavior causes results to be filtered incorrectly. An attacker could exploit this vulnerability by using either NETCONF, RESTCONF, or gRPC Network Management Interface (gNMI) protocols and query data on paths that may have been denied by the NACM configuration. A successful exploit could allow the attacker to access data that should have been restricted according to the NACM configuration. Note: This vulnerability requires that the attacker obtain the credentials from a valid user with privileges lower than 15, and that NACM was configured to provide restricted read access for that user.

Published: 2025-05-07T17:34:14.978Z
Updated: 2025-05-07T19:45:40.776Z

A vulnerability in Cisco IOS XE Wireless Controller Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient input validation of access point (AP) Cisco Discovery Protocol (CDP) neighbor reports when they are processed by the wireless controller. An attacker could exploit this vulnerability by sending a crafted CDP packet to an AP. A successful exploit could allow the attacker to cause an unexpected reload of the wireless controller that is managing the AP, resulting in a DoS condition that affects the wireless network.

Published: 2025-05-07T17:35:14.380Z
Updated: 2025-05-07T19:45:13.020Z