Cisco IOS XE SD-WAN 16.10.2

A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS Software and Cisco IOS XE Software could allow the following: An authenticated, remote attacker with low privileges could cause a denial of service (DoS) condition on an affected device that is running Cisco IOS Software or Cisco IOS XE Software. To cause the DoS, the attacker must have the SNMPv2c or earlier read-only community string or valid SNMPv3 user credentials. An authenticated, remote attacker with high privileges could execute code as the root user on an affected device that is running Cisco IOS XE Software. To execute code as the root user, the attacker must have the SNMPv1 or v2c read-only community string or valid SNMPv3 user credentials and administrative or privilege 15 credentials on the affected device. An attacker could exploit this vulnerability by sending a crafted SNMP packet to an affected device over IPv4 or IPv6 networks. This vulnerability is due to a stack overflow condition in the SNMP subsystem of the affected software. A successful exploit could allow a low-privileged attacker to cause the affected system to reload, resulting in a DoS condition, or allow a high-privileged attacker to execute arbitrary code as the root user and obtain full control of the affected system. Note: This vulnerability affects all versions of SNMP.

Published: 2025-09-24T17:10:42.891Z
Updated: 2026-02-26T17:48:03.098Z

A vulnerability in the implementation of the Simple Network Management Protocol Version 3 (SNMPv3) feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to poll an affected device using SNMP, even if the device is configured to deny SNMP traffic from an unauthorized source or the SNMPv3 username is removed from the configuration. This vulnerability exists because of the way that the SNMPv3 configuration is stored in the Cisco IOS Software and Cisco IOS XE Software startup configuration. An attacker could exploit this vulnerability by polling an affected device from a source address that should have been denied. A successful exploit could allow the attacker to perform SNMP operations from a source that should be denied. Note: The attacker has no control of the SNMPv3 configuration. To exploit this vulnerability, the attacker must have valid SNMPv3 user credentials. For more information, see the section of this advisory.

Published: 2025-05-07T17:18:44.414Z
Updated: 2025-05-07T19:46:24.894Z

A vulnerability in the implementation of the Simple Network Management Protocol (SNMP) IPv4 access control list (ACL) feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to perform SNMP polling of an affected device, even if it is configured to deny SNMP traffic.  This vulnerability exists because Cisco IOS Software and Cisco IOS XE Software do not support extended IPv4 ACLs for SNMP, but they do allow administrators to configure extended named IPv4 ACLs that are attached to the SNMP server configuration without a warning message. This can result in no ACL being applied to the SNMP listening process. An attacker could exploit this vulnerability by performing SNMP polling of an affected device. A successful exploit could allow the attacker to perform SNMP operations that should be denied. The attacker has no control of the SNMP ACL configuration and would still need a valid SNMP version 2c (SNMPv2c) community string or SNMP version 3 (SNMPv3) user credentials. SNMP with IPv6 ACL configurations is not affected. For more information, see the section of this advisory.

Published: 2024-11-15T14:52:34.137Z
Updated: 2024-11-15T16:20:59.945Z