Cisco Catalyst C3850-12x48u-e -

A vulnerability in Cisco IOS XE Software for Cisco Catalyst 3650 and Catalyst 3850 Series Switches could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to improper resource management when processing traffic that is received on the management interface. An attacker could exploit this vulnerability by sending a high rate of traffic to the management interface. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

Published: 2023-09-27T17:20:18.221Z
Updated: 2025-06-18T14:10:56.951Z

A vulnerability in the egress MPLS packet processing function of Cisco IOS XE Software for Cisco Catalyst 3650, Catalyst 3850, and Catalyst 9000 Family Switches could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient input validation of IPv4 traffic. An attacker could exploit this vulnerability by sending a malformed packet out of an affected MPLS-enabled interface. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

Published: 2022-10-10T20:43:15.373Z
Updated: 2024-11-01T18:49:31.851Z

A vulnerability in the password-recovery disable feature of Cisco IOS XE ROM Monitor (ROMMON) Software for Cisco Catalyst Switches could allow an unauthenticated, local attacker to recover the configuration or reset the enable password. This vulnerability is due to a problem with the file and boot variable permissions in ROMMON. An attacker could exploit this vulnerability by rebooting the switch into ROMMON and entering specific commands through the console. A successful exploit could allow the attacker to read any file or reset the enable password.

Published: 2022-10-10T20:43:16.392Z
Updated: 2024-11-01T18:49:04.147Z

Layer 2 network filtering capabilities such as IPv6 RA guard or ARP inspection can be bypassed using combinations of VLAN 0 headers and LLC/SNAP headers.

Published: 2022-09-27T17:55:09.203Z
Updated: 2025-11-04T19:12:25.432Z

A vulnerability in the IP Address Resolution Protocol (ARP) feature of Cisco IOS XE Software for Cisco ASR 1000 Series Aggregation Services Routers with a 20-Gbps Embedded Services Processor (ESP) installed could allow an unauthenticated, adjacent attacker to cause an affected device to reload, resulting in a denial of service condition. The vulnerability is due to insufficient error handling when an affected device has reached platform limitations. An attacker could exploit this vulnerability by sending a malicious series of IP ARP messages to an affected device. A successful exploit could allow the attacker to exhaust system resources, which would eventually cause the affected device to reload.

Published: 2020-09-24T17:51:52.664Z
Updated: 2024-11-13T18:00:09.880Z