Sg350X 48P Firmware

A vulnerability with the access control list (ACL) management within a stacked switch configuration of Cisco Business 250 Series Smart Switches and Business 350 Series Managed Switches could allow an unauthenticated, remote attacker to bypass protection offered by a configured ACL on an affected device. This vulnerability is due to incorrect processing of ACLs on a stacked configuration when either the primary or backup switches experience a full stack reload or power cycle. An attacker could exploit this vulnerability by sending crafted traffic through an affected device. A successful exploit could allow the attacker to bypass configured ACLs, causing traffic to be dropped or forwarded in an unexpected manner. The attacker does not have control over the conditions that result in the device being in the vulnerable state. Note: In the vulnerable state, the ACL would be correctly applied on the primary devices but could be incorrectly applied to the backup devices.

Published: 2024-01-26T17:27:08.928Z
Updated: 2024-11-13T14:55:13.733Z

A vulnerability in the web-based management interface of multiple Cisco Small Business Series Switches could allow an unauthenticated, remote attacker to replay valid user session credentials and gain unauthorized access to the web-based management interface of an affected device. This vulnerability is due to insufficient expiration of session credentials. An attacker could exploit this vulnerability by conducting a man-in-the-middle attack against an affected device to intercept valid session credentials and then replaying the intercepted credentials toward the same device at a later time. A successful exploit could allow the attacker to access the web-based management interface with administrator privileges.

Published: 2021-11-04T15:40:23.357Z
Updated: 2024-11-07T21:43:18.199Z

A vulnerability in the IPv6 packet processing engine of Cisco Small Business Smart and Managed Switches could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to insufficient validation of incoming IPv6 traffic. An attacker could exploit this vulnerability by sending a crafted IPv6 packet through an affected device. A successful exploit could allow the attacker to cause the switch management CLI to stop responding, resulting in a DoS condition. This vulnerability is specific to IPv6 traffic. IPv4 traffic is not affected.

Published: 2020-08-26T16:15:54.968Z
Updated: 2024-11-13T18:12:35.608Z

A vulnerability in session management for the web-based interface of Cisco Small Business Smart and Managed Switches could allow an unauthenticated, remote attacker to defeat authentication protections and gain unauthorized access to the management interface. The attacker could obtain the privileges of the highjacked session account, which could include administrator privileges on the device. The vulnerability is due to the use of weak entropy generation for session identifier values. An attacker could exploit this vulnerability to determine a current session identifier through brute force and reuse that session identifier to take over an ongoing session. In this way, an attacker could take actions within the management interface with privileges up to the level of the administrative user.

Published: 2020-07-02T04:20:12.834Z
Updated: 2024-11-15T16:57:52.709Z

A vulnerability in the Secure Shell (SSH) authentication process of Cisco Small Business Switches software could allow an attacker to bypass client-side certificate authentication and revert to password authentication. The vulnerability exists because OpenSSH mishandles the authentication process. An attacker could exploit this vulnerability by attempting to connect to the device via SSH. A successful exploit could allow the attacker to access the configuration as an administrative user if the default credentials are not changed. There are no workarounds available; however, if client-side certificate authentication is enabled, disable it and use strong password authentication. Client-side certificate authentication is disabled by default.

Published: 2019-05-03T16:40:17.005Z
Updated: 2024-11-20T17:23:10.627Z