Cisco Catalyst 9300-48t-a -

A vulnerability in the DHCP snooping feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to a crafted IPv4 DHCP request packet being mishandled when endpoint analytics are enabled. An attacker could exploit this vulnerability by sending a crafted DHCP request through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: The attack vector is listed as network because a DHCP relay anywhere on the network could allow exploits from networks other than the adjacent one.

Published: 2024-03-27T16:53:53.073Z
Updated: 2024-08-27T21:04:37.666Z

A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform an injection attack against an affected device. This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending crafted input to the web UI. A successful exploit could allow the attacker to execute arbitrary Cisco IOS XE Software CLI commands with level 15 privileges. Note: This vulnerability is exploitable only if the attacker obtains the credentials for a Lobby Ambassador account. This account is not configured by default.

Published: 2023-09-27T17:19:17.664Z
Updated: 2025-12-16T18:23:20.501Z

A vulnerability in Cisco IOS XE Software for Cisco Catalyst 9300 Series Switches could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to errors that occur when retrieving the public release key that is used for image signature verification. An attacker could exploit this vulnerability by modifying specific variables in the Serial Peripheral Interface (SPI) flash memory of an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Note: In Cisco IOS XE Software releases 16.11.1 and later, the complexity of an attack using this vulnerability is high. However, an attacker with level-15 privileges could easily downgrade the Cisco IOS XE Software on a device to a release that would lower the attack complexity.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-28T16:32:09.922Z

A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-25T16:02:26.498Z

A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform a directory traversal and access resources that are outside the filesystem mountpoint of the web UI. This vulnerability is due to an insufficient security configuration. An attacker could exploit this vulnerability by sending a crafted request to the web UI. A successful exploit could allow the attacker to gain read access to files that are outside the filesystem mountpoint of the web UI. Note: These files are located on a restricted filesystem that is maintained for the web UI. There is no ability to write to any files on this filesystem.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-25T16:02:41.984Z