Cisco Catalyst 9800-l-c -

A vulnerability in the DHCP snooping feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to a crafted IPv4 DHCP request packet being mishandled when endpoint analytics are enabled. An attacker could exploit this vulnerability by sending a crafted DHCP request through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: The attack vector is listed as network because a DHCP relay anywhere on the network could allow exploits from networks other than the adjacent one.

Published: 2024-03-27T16:53:53.073Z
Updated: 2024-08-27T21:04:37.666Z

A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform an injection attack against an affected device. This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending crafted input to the web UI. A successful exploit could allow the attacker to execute arbitrary Cisco IOS XE Software CLI commands with level 15 privileges. Note: This vulnerability is exploitable only if the attacker obtains the credentials for a Lobby Ambassador account. This account is not configured by default.

Published: 2023-09-27T17:19:17.664Z
Updated: 2025-12-16T18:23:20.501Z

A vulnerability in the access point (AP) joining process of the Control and Provisioning of Wireless Access Points (CAPWAP) protocol of Cisco IOS XE Software for Wireless LAN Controllers (WLCs) could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to a logic error that occurs when certain conditions are met during the AP joining process. An attacker could exploit this vulnerability by adding an AP that is under their control to the network. The attacker then must ensure that the AP successfully joins an affected wireless controller under certain conditions. Additionally, the attacker would need the ability to restart a valid AP that was previously connected to the controller. A successful exploit could allow the attacker to cause the affected device to restart unexpectedly, resulting in a DoS condition.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-25T16:02:11.931Z

A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-25T16:02:26.498Z

A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform a directory traversal and access resources that are outside the filesystem mountpoint of the web UI. This vulnerability is due to an insufficient security configuration. An attacker could exploit this vulnerability by sending a crafted request to the web UI. A successful exploit could allow the attacker to gain read access to files that are outside the filesystem mountpoint of the web UI. Note: These files are located on a restricted filesystem that is maintained for the web UI. There is no ability to write to any files on this filesystem.

Published: 2023-03-23T00:00:00.000Z
Updated: 2024-10-25T16:02:41.984Z