Juniper JUNOS 21.1

A Concurrent Execution using Shared Resource with Improper Synchronization ('Race Condition') vulnerability the Routing Protocol Daemon (rpd) of Juniper Networks Junos OS and Juniper Networks Junos OS Evolved allows an unauthenticated, network-based attacker to inject incremental routing updates when BGP multipath is enabled, causing rpd to crash and restart, resulting in a Denial of Service (DoS). Since this is a timing issue (race condition), the successful exploitation of this vulnerability is outside the attacker's control.  However, continued receipt and processing of this packet may create a sustained Denial of Service (DoS) condition. On all Junos OS and Junos OS Evolved platforms with BGP multipath enabled, a specific multipath calculation removes the original next hop from the multipath lead routes nexthop-set. When this change happens, multipath relies on certain internal timing to record the update.  Under certain circumstance and with specific timing, this could result in an rpd crash. This issue only affects systems with BGP multipath enabled. This issue affects: Junos OS: * All versions of 21.1 * from 21.2 before 21.2R3-S7, * from 21.4 before 21.4R3-S6, * from 22.1 before 22.1R3-S5, * from 22.2 before 22.2R3-S3, * from 22.3 before 22.3R3-S2, * from 22.4 before 22.4R3, * from 23.2 before 23.2R2. Junos OS Evolved: * All versions of 21.1-EVO, * All versions of 21.2-EVO, * from 21.4-EVO before 21.4R3-S6-EVO, * from 22.1-EVO before 22.1R3-S5-EVO, * from 22.2-EVO before 22.2R3-S3-EVO, * from 22.3-EVO before 22.3R3-S2-EVO, * from 22.4-EVO before 22.4R3-EVO, * from 23.2-EVO before 23.2R2-EVO. Versions of Junos OS before 21.1R1 are unaffected by this vulnerability. Versions of Junos OS Evolved before 21.1R1-EVO are unaffected by this vulnerability.

Published: 2024-07-10T22:32:34.310Z
Updated: 2024-08-02T04:26:15.931Z

A Missing Authentication for Critical Function vulnerability in the Packet Forwarding Engine (pfe) of Juniper Networks Junos OS on MX Series with SPC3, and SRX Series allows an unauthenticated network-based attacker to cause limited impact to the integrity or availability of the device. If a device is configured with IPsec authentication algorithm hmac-sha-384 or hmac-sha-512, tunnels are established normally but for traffic traversing the tunnel no authentication information is sent with the encrypted data on egress, and no authentication information is expected on ingress. So if the peer is an unaffected device transit traffic is going to fail in both directions. If the peer is an also affected device transit traffic works, but without authentication, and configuration and CLI operational commands indicate authentication is performed. This issue affects Junos OS: * All versions before 20.4R3-S7, * 21.1 versions before 21.1R3,  * 21.2 versions before 21.2R2-S1, 21.2R3,  * 21.3 versions before 21.3R1-S2, 21.3R2.

Published: 2024-04-12T15:25:24.733Z
Updated: 2024-08-09T20:08:44.052Z

A Use After Free vulnerability in command processing of Juniper Networks Junos OS on MX Series allows a local, authenticated attacker to cause the broadband edge service manager daemon (bbe-smgd) to crash upon execution of specific CLI commands, creating a Denial of Service (DoS) condition.  The process crashes and restarts automatically. When specific CLI commands are executed, the bbe-smgd daemon attempts to write into an area of memory (mgd socket) that was already closed, causing the process to crash.  This process manages and controls the configuration of broadband subscriber sessions and services.  While the process is unavailable, additional subscribers will not be able to connect to the device, causing a temporary Denial of Service condition. This issue only occurs if Graceful Routing Engine Switchover (GRES) and Subscriber Management are enabled. This issue affects Junos OS: * All versions before 20.4R3-S5, * from 21.1 before 21.1R3-S4, * from 21.2 before 21.2R3-S3, * from 21.3 before 21.3R3-S5, * from 21.4 before 21.4R3-S5, * from 22.1 before 22.1R3, * from 22.2 before 22.2R3, * from 22.3 before 22.3R2;

Published: 2024-04-16T20:03:56.292Z
Updated: 2024-08-02T01:32:07.268Z

An Unsupported Feature in the UI vulnerability in Juniper Networks Junos OS on MX Series and EX9200 Series allows an unauthenticated, network-based attacker to cause partial impact to the integrity of the device. If the "tcp-reset" option is added to the "reject" action in an IPv6 filter which matches on "payload-protocol", packets are permitted instead of rejected. This happens because the payload-protocol match criteria is not supported in the kernel filter causing it to accept all packets without taking any other action. As a fix the payload-protocol match will be treated the same as a "next-header" match to avoid this filter bypass. This issue doesn't affect IPv4 firewall filters. This issue affects Juniper Networks Junos OS on MX Series and EX9200 Series: * All versions earlier than 20.4R3-S7; * 21.1 versions earlier than 21.1R3-S5; * 21.2 versions earlier than 21.2R3-S5; * 21.3 versions earlier than 21.3R3-S4; * 21.4 versions earlier than 21.4R3-S4; * 22.1 versions earlier than 22.1R3-S2; * 22.2 versions earlier than 22.2R3-S2; * 22.3 versions earlier than 22.3R2-S2, 22.3R3; * 22.4 versions earlier than 22.4R1-S2, 22.4R2-S2, 22.4R3.

Published: 2024-01-12T00:55:07.323Z
Updated: 2025-06-17T21:09:19.924Z

An Improper Neutralization of Equivalent Special Elements vulnerability in the Packet Forwarding Engine (PFE) of Juniper Networks Junos OS on PTX Series allows a unauthenticated, adjacent attacker to cause a Denial of Service (DoS). When MPLS packets are meant to be sent to a flexible tunnel interface (FTI) and if the FTI tunnel is down, these will hit the reject NH, due to which the packets get sent to the CPU and cause a host path wedge condition. This will cause the FPC to hang and requires a manual restart to recover. Please note that this issue specifically affects PTX1000, PTX3000, PTX5000 with FPC3, PTX10002-60C, and PTX10008/16 with LC110x. Other PTX Series devices and Line Cards (LC) are not affected. The following log message can be seen when the issue occurs: Cmerror Op Set: Host Loopback: HOST LOOPBACK WEDGE DETECTED IN PATH ID <id> (URI: /fpc/<fpc>/pfe/<pfe>/cm/<cm>/Host_Loopback/<cm>/HOST_LOOPBACK_MAKE_CMERROR_ID[<id>]) This issue affects Juniper Networks Junos OS: * All versions earlier than 20.4R3-S8; * 21.1 versions earlier than 21.1R3-S4; * 21.2 versions earlier than 21.2R3-S6; * 21.3 versions earlier than 21.3R3-S3; * 21.4 versions earlier than 21.4R3-S5; * 22.1 versions earlier than 22.1R2-S2, 22.1R3; * 22.2 versions earlier than 22.2R2-S1, 22.2R3.

Published: 2024-01-12T00:53:38.834Z
Updated: 2025-06-17T21:09:19.373Z