Juniper JUNOS 21.4 R2

An Improper Check for Unusual or Exceptional Conditions vulnerability in the flow daemon (flowd) of Juniper Networks Junos OS on SRX Series allows an attacker sending a specific, malformed ICMPv6 packet to cause the srxpfe process to crash and restart. Continued receipt and processing of these packets will repeatedly crash the srxpfe process and sustain the Denial of Service (DoS) condition. During NAT64 translation, receipt of a specific, malformed ICMPv6 packet destined to the device will cause the srxpfe process to crash and restart. This issue cannot be triggered using IPv4 nor other IPv6 traffic. This issue affects Junos OS on SRX Series: * all versions before 21.2R3-S10, * all versions of 21.3, * from 21.4 before 21.4R3-S12, * all versions of 22.1, * from 22.2 before 22.2R3-S8, * all versions of 22.4, * from 22.4 before 22.4R3-S9, * from 23.2 before 23.2R2-S6, * from 23.4 before 23.4R2-S7, * from 24.2 before 24.2R2-S3, * from 24.4 before 24.4R2-S3, * from 25.2 before 25.2R1-S2, 25.2R2.

Published: 2026-04-09T21:38:08.493Z
Updated: 2026-04-10T13:56:16.375Z

A Time-of-check Time-of-use (TOCTOU) Race Condition vulnerability in the method to collect FPC Ethernet firmware statistics of Juniper Networks Junos OS on MX10k Series allows a local, low-privileged attacker executing the 'show system firmware' CLI command to cause an LC480 or LC2101 line card to reset. On MX10k Series systems with LC480 or LC2101 line cards, repeated execution of the 'show system firmware' CLI command can cause the line card to crash and restart. Additionally, some time after the line card crashes, chassisd may also crash and restart, generating a core dump.This issue affects Junos OS on MX10k Series:  * all versions before 21.2R3-S10,  * from 21.4 before 21.4R3-S9,  * from 22.2 before 22.2R3-S7,  * from 22.4 before 22.4R3-S6,  * from 23.2 before 23.2R2-S2,  * from 23.4 before 23.4R2-S3,  * from 24.2 before 24.2R2.

Published: 2026-01-15T20:24:20.087Z
Updated: 2026-01-15T20:50:28.949Z

An Improper Check for Unusual or Exceptional Conditions vulnerability in the packet forwarding engine (PFE) of Juniper Networks Junos OS on EX4k Series and QFX5k Series platforms allows an unauthenticated network-adjacent attacker flapping an interface to cause traffic between VXLAN Network Identifiers (VNIs) to drop, leading to a Denial of Service (DoS). On all EX4k and QFX5k platforms, a link flap in an EVPN-VXLAN configuration Link Aggregation Group (LAG) results in Inter-VNI traffic dropping when there are multiple load-balanced next-hop routes for the same destination. This issue is only applicable to systems that support EVPN-VXLAN Virtual Port-Link Aggregation Groups (VPLAG), such as the QFX5110, QFX5120, QFX5200, EX4100, EX4300, EX4400, and EX4650. Service can only be restored by restarting the affected FPC via the 'request chassis fpc restart slot <slot-number>' command. This issue affects Junos OS on EX4k and QFX5k Series:  * all versions before 21.4R3-S12,  * all versions of 22.2 * from 22.4 before 22.4R3-S8,  * from 23.2 before 23.2R2-S5,  * from 23.4 before 23.4R2-S5,  * from 24.2 before 24.2R2-S3, * from 24.4 before 24.4R2.

Published: 2026-01-15T20:23:29.682Z
Updated: 2026-01-15T20:51:57.933Z

An Improper Handling of Exceptional Conditions vulnerability in the packet forwarding engine (PFE) of Juniper Networks Junos OS on SRX Series allows an unauthenticated network-based attacker sending a specific ICMP packet through a GRE tunnel to cause the PFE to crash and restart. When PowerMode IPsec (PMI) and GRE performance acceleration are enabled and the device receives a specific ICMP packet, a crash occurs in the SRX PFE, resulting in traffic loss. PMI is enabled by default, and GRE performance acceleration can be enabled by running the configuration command shown below. PMI is a mode of operation that provides IPsec performance improvements using Vector Packet Processing. Note that PMI with GRE performance acceleration is only supported on specific SRX platforms. This issue affects Junos OS on the SRX Series: * all versions before 21.4R3-S12,  * from 22.4 before 22.4R3-S8,  * from 23.2 before 23.2R2-S5,  * from 23.4 before 23.4R2-S5,  * from 24.2 before 24.2R2-S3,  * from 24.4 before 24.4R2-S1,  * from 25.2 before 25.2R1-S1, 25.2R2.

Published: 2026-01-15T20:20:32.530Z
Updated: 2026-01-16T16:20:14.792Z

A Loop with Unreachable Exit Condition ('Infinite Loop') vulnerability in the SIP application layer gateway (ALG) of Juniper Networks Junos OS on SRX Series and MX Series with MX-SPC3 or MS-MPC allows an unauthenticated network-based attacker sending specific SIP messages over TCP to crash the flow management process, leading to a Denial of Service (DoS). On SRX Series, and MX Series with MX-SPC3 or MS-MPC service cards, receipt of multiple SIP messages causes the SIP headers to be parsed incorrectly, eventually causing a continuous loop and leading to a watchdog timer expiration, crashing the flowd process on SRX Series and MX Series with MX-SPC3, or mspmand process on MX Series with MS-MPC. This issue only occurs over TCP. SIP messages sent over UDP cannot trigger this issue. This issue affects Junos OS on SRX Series and MX Series with MX-SPC3 and MS-MPC: * all versions before 21.2R3-S10,  * from 21.4 before 21.4R3-S12,  * from 22.4 before 22.4R3-S8,  * from 23.2 before 23.2R2-S5,  * from 23.4 before 23.4R2-S6,  * from 24.2 before 24.2R2-S3,  * from 24.4 before 24.4R2-S1,  * from 25.2 before 25.2R1-S1, 25.2R2.

Published: 2026-01-15T20:19:22.158Z
Updated: 2026-01-16T16:26:02.071Z